slackoverflow

Welcome to slackoverflow, where you can hone your slacking skills!

Feel free to check out our blog

harbor examines quarantine

0 votes
IMPORTANT: Maintain the 1?4 inch space around cabinets, pipes, toilet flanges and any obstacle in the floor. For plank installation, [url=http://wpcfloormaterial.com/solution/long-life-wpc-deck-flooring.html]Recyclable Materials Decking Products, Long Life WPC Deck Flooring[/url] staggering the end joints a minimum of 6 inches is required. For tile installation, staggering the end joints a minimum of 3 inches is required. Note: Do not install four corners together, as this will not provide a stable installation. [url=http://wpcfloormaterial.com/solution/wood-plastic-outdoor-flower-box.html]Wood Plastic Outdoor Flower Box, Build an Outdoor Flower Box[/url] Clicking Planks/Tiles Together: To click the end joint of the plank/tile together, click the short side of the plank/tile vertically into the previous one by pressing it by hand and rolling it with a hand roller or seam roller to ensure a fully compressed tight fit. To click the length joint of the plank/tile together, you can place long joint together, lifting slightly to engage lock. Rotate downward, clicking together for a tight fit. Use a small hand roller or seam roller to press/lock the compression fit end joint. [url=http://wpcfloormaterial.com/solution/wood-plastic-composite-decking-around-the-pool.html]Wood Plastic Composite Decking Around the Pool[/url] If there are any gaps, we recommend using a small scrap piece of plank/tile with the lock on the edge. Lock groove-to-tongue or tongue-to-groove for this application. Lock the scrap piece to the area requiring tapping, and lightly tap the edge of the material. This will bring the tile edges tight together. Cut the plank/tile by scoring through the top wear layer with a utility knife then snap the plank/ tile across the score. Install adjoining rows as you did the first; one piece at a time. Holding the plank/tile at a slight angle, place it against the profile in the first row. Rotate the plank/tile down to secure the length joint assuring there are no gaps along the joint. [url=http://wpcfloormaterial.com/solution/wall-panels-decorative.html]Wood Plastic Wall Panels, Wall Panels Decorative[/url] The adjoining planks/tiles are aligned by sliding the long joint into position, shifting it to properly match the end joint against the previous plank/tile. Repeat until you reach the final row of material. To install the final row of planks/tiles, you will usually need to cut them. We recommend the following: lay a panel on top of the last row installed. Lay another plank/tile against the edge of the wall. Mark the plank/tile underneath. Cut the plank/tile through the wear layer and snap along the score. Install the last row leaving ample expansion space. Once installation is complete we recommend rolling the floor with a 100lb roller to insure the flooring is locked in well. Related Sites: [url=http://syntheticboard.com/diy-deck/6208.html]cost of synthetic porch boards[/url] [url=http://syntheticboard.com/wood-floor/2889.html]outdoor teak wood locking floor[/url] [url=http://syntheticboard.com/polymer-board/5190.html]build lattice panels indoor[/url] [url=http://syntheticboard.com/polymer-board/205.html]Plastic Court Decking Material[/url]
asked Jun 19 by qzz10011 (85,000 points)

Please log in or register to answer this question.

...